|
|
| Line 4: |
Line 4: |
| | Thanks for the blog post.Really thank you! Keep writing. | | Thanks for the blog post.Really thank you! Keep writing. |
| | | | |
| - | == Interface ==
| + | T15sVS Im thankful for the blog article. Fantastic. |
| - | An '''interface device''' is needed to connect to the layout or command station. However the JMRI programs can be installed and run on your computer without an interface device if you wish to preview it only.
| + | |
| - | | + | |
| - | Presently there are several interface devices which can be used to connect your computer to your programming track or your layout in order to run the JMRI suite, note that many are serial devices and you may need a [[USB to Serial adapter]] to use them with newer computers.
| + | |
| - | | + | |
| - | === Digitrax - LocoNet Systems===
| + | |
| - | ( Digitrax, Fleischmann, Uhlenbrock )
| + | |
| - | -- SPROG II from [http://www.sprog-dcc.co.uk sprog-dcc.co.uk]
| + | |
| - | -- Locobuffer II from [http://www.rr-cirkits.com rr-cirkits.com]
| + | |
| - | Due to problems inherent in the use of a Serial connection, the USB version of either of the above is preferred.
| + | |
| - | [Note - This can be debated on the 'discussion' page tab above!].
| + | |
| - | | + | |
| - | This contributor understands the Sprog to be stand-alone, not LocoNet, see below for its description.
| + | |
| - | | + | |
| - | ===XPressNet Based Systems===
| + | |
| - | (Atlas, Lenz, ZTC Controls, and Roco)
| + | |
| - | -- LI100,LI100F, LI101F
| + | |
| - | -- LI-USB ''Needs JMRI 1.5.7 or better''
| + | |
| - | -- XPA - Can't be used to program decoders
| + | |
| - | -- [http://www.terdina.net/rails/ XnTcp] - DIY solution using TCP/IP
| + | |
| - | | + | |
| - | ===Other Systems===
| + | |
| - | ==== SPROG II from [http://www.sprog-dcc.co.uk sprog-dcc.co.uk]====
| + | |
| - | SPROG is not an interface to a system, but a stand alone programmer/controller.
| + | |
| - | SPROG allows programming of decoders using DecoderPro, supporting all the major
| + | |
| - | types. SPROG II is available with direct serial or USB interfaces, and can also
| + | |
| - | run a small layout (max current is 1/2 Amp) using the DecoderPro throttles.
| + | |
| - | ==== [[TMCC]] ====
| + | |
| - | TMCC is the Lionel interface for controlling their trains. Initial support for it
| + | |
| - | was added in JMRI 1.7.3. All you need to connect it is a straight-through serial cable.
| + | |
| - | | + | |
| - | [[Category:FAQ]]
| + | |
| - | [[Category:Hardware]]
| + | |
lilaro
Rs61tK I really enjoy the article.Much thanks again. Will read on...
T15sVS Im thankful for the blog article. Fantastic.
