From Jmri
(Difference between revisions)
|
|
| (29 intermediate revisions not shown) |
| Line 1: |
Line 1: |
| - | This FAQ should be the first place to check for answers to your questions. Many times the answer is hidden in the mists of our [http://groups.yahoo.com/group/jmriusers Yahoo group archives]. Hopefully this page may help those mists clear!
| + | xw40lo Muchos Gracias for your article.Really thank you! |
| - | | + | |
| - | ==No Loco Detected==
| + | |
| - | With thanks to Paul Bender for the following notes:
| + | |
| - | | + | |
| - | Basically, the error "no loco detected" means that the decoder didn't
| + | |
| - | respond when the command station sent out the programming request. On a
| + | |
| - | Lenz system, this is the same as getting an "Error 2" when programming
| + | |
| - | from a hand held throttle.
| + | |
| - | | + | |
| - | One possible cause of this is that the CV requested isn't actually
| + | |
| - | defined in the decoder. See if you can read the problem CV using a hand
| + | |
| - | held throttle. If you get the same result on the handheld, then the CV
| + | |
| - | may not actually be defined.
| + | |
| - | | + | |
| - | ==Timeout talking to command station==
| + | |
| - | Anyone?
| + | |
Current revision as of 09:29, 20 September 2012
xw40lo Muchos Gracias for your article.Really thank you!
