Basic Techniques
From Polarity
Contents |
Placing Leaners
The basic move in Polarity is to place a leaner against a foundation piece on the board. This is achieved by balancing the action piece against the magnetic field of the foundation piece.
Basic Method
Bring the action piece into play at an angle, with the underside of the piece facing slightly towards the foundation piece. Approach slowly, and wait until you can feel the pressure generated by the magnetic repulsion. Place the bottom edge of the action disk against the mat, and slowly lower it against the field. Carefully let go - if you have placed the leaner correctly it should not move significantly.
Stacks
Leaners can be placed against stacks using the same techniques. Be warned, because the higher the stack the more powerful the field, and therefore the angle will be steeper and the piece further away.
Conversions
This basic technique relies on deliberately creating a fault by dropping a leaner onto the board to become a foundation piece. This allows further leaners to be played against the converted pieces.
Basic Method
Slowly bring the action disc down horizontally, directly above the foundation piece. The lower you get the lower the leaner will lean. Eventually the leaner should drop to the mat. Remove the action piece quickly to avoid creating further faults, and return it to your stack.
Best Results
When placing leaners which you intend to convert, ensure they are as flat and as far away from their foundation pieces as possible. This minimises the chance that they will attract to the foundation piece, and also means that you do not need to move the action piece as close.
