Scaling IP Addresses
From Mycomputer Notes
(Difference between revisions)
(→Static Translations) |
(→Static Translations) |
||
| Line 20: | Line 20: | ||
Router(config)#interface <TYPE> <NUMBER> | Router(config)#interface <TYPE> <NUMBER> | ||
| - | Router(config)#ip nat | + | Router(config)#ip nat outside |
Revision as of 20:52, 13 November 2006
Configuring NAT & PAT
Static Translations
Stattic Trasnlation are entered direclty into the configuration and are always entered in the translation table. To configured static inside source address translation perform the task below:
- - Establish static translation between an inside local address and an insie global address in Global Configuration Mode.
Router(Config)#ip nat inside source static <LOCAL-IP> <GLOBAL-IP>
- - Enter the interface mode and specify the inside interface & Mark the interface as connected to the inside
Router(config)#interface <TYPE> <NUMBER> Router(config)#ip nat inside
- - Specify the outside inteface & Mark the interface as connected to the outised
Router(config)#interface <TYPE> <NUMBER> Router(config)#ip nat outside
