From Mycomputer Notes

Revision as of 20:49, 13 November 2006 (edit) 70.82.223.90 (Talk) (→Static Translations) ← Previous diff		Revision as of 20:49, 13 November 2006 (edit) (undo) 70.82.223.90 (Talk) (→Static Translations) Next diff →
Line 13:		Line 13:
	# - Enter the interface mode and specify the inside interface.		# - Enter the interface mode and specify the inside interface.
-	Mark the interface as connected to the inside	+	Mark the interface as connected to the inside
	Router(config)#interface <TYPE> <NUMBER>		Router(config)#interface <TYPE> <NUMBER>
	Router(config)#ip nat inside		Router(config)#ip nat inside

---

Revision as of 20:49, 13 November 2006

Configuring NAT & PAT

Static Translations

Stattic Trasnlation are entered direclty into the configuration and are always entered in the translation table. To configured static inside source address translation perform the task below:

1. - Establish static translation between an inside local address and an insie global address in Global Configuration Mode.

Router(Config)#ip nat inside source static <LOCAL-IP> <GLOBAL-IP>

1. - Enter the interface mode and specify the inside interface.

Mark the interface as connected to the inside

Router(config)#interface <TYPE> <NUMBER>
Router(config)#ip nat inside