Scaling IP Addresses
From Mycomputer Notes
(Difference between revisions)
(→Configuring NAT & PAT) |
(→Static Translations) |
||
| Line 8: | Line 8: | ||
To configured static inside source address translation perform the task below: | To configured static inside source address translation perform the task below: | ||
| - | # - | + | # - Establish static translation between an inside local address and an insie global address in Global Configuration Mode. |
| + | |||
| + | Router(Config)#ip nat inside source static <LOCAL-IP> <GLOBAL-IP> | ||
| + | |||
| + | # - Enter the interface mode and specify the inside interface. | ||
| + | Mark the interface as connected to the inside | ||
| + | |||
| + | Router(config)#interface <TYPE> <NUMBER> | ||
| + | Router(config)#ip nat inside | ||
Revision as of 20:49, 13 November 2006
Configuring NAT & PAT
Static Translations
Stattic Trasnlation are entered direclty into the configuration and are always entered in the translation table. To configured static inside source address translation perform the task below:
- - Establish static translation between an inside local address and an insie global address in Global Configuration Mode.
Router(Config)#ip nat inside source static <LOCAL-IP> <GLOBAL-IP>
- - Enter the interface mode and specify the inside interface.
Mark the interface as connected to the inside
Router(config)#interface <TYPE> <NUMBER> Router(config)#ip nat inside
