Advanced Methods

From Polarity

(Difference between revisions)
(Leaners in a Line)
(Leaners in a Line: Copied in almost verbatim from Jean-Luc Romano's tip on the website - just to clarify how the leaner should actually be placed.)
Line 1: Line 1:
==Leaners in a Line==
==Leaners in a Line==
-
You can stand discs on other standing discs.
+
It is possible, though difficult, to stand discs on other standing discs. It is advisable to practice this technique without other magnets nearby. Note that in a game it is unlikely that an opponent will let you exploit this technique fully, and you might be limited to a small leaner chain.
-
Try to lay the first standing disc as low as possible. Bring the next disc along the mat tilted a bit until you see the standing disc rise up a bit. Play with the distance and angle until you can stand it. Stand it as low as possible again if you plan on making a longer line.  
+
Try to lay the first [[leaner|standing disc]] as low as possible. Bring the next disc along the mat carefully and slowly slide this disc towards the leaner until the leaner starts to wobble due to the disc you are moving. If the first leaner falls flat to the ground, then you probably placed it too far from the foundation disc. Slowly increase the angle of the third disc; the more vertical you make the third disc, the more vertical the second disc (the first leaner) will tend to become. And the more vertical the second and third discs are, the more their attraction will be to each other. Therefore, be sure to stop increasing the angle of the third disc as soon as you see the angle of the second disc increase. Slide the third disc back and at the same time lift it up some more: This is a tricky step: At the same time, you want to both barely tilt the third disc and barely move it away. Increasing the angle of the third disc increases the attraction it has to the second disc (preventing it from falling flat), while moving it away prevents the leaner discs from snapping together. It is important to note, however, that the movements in this step are very small. Any movement more than a millimeter is too large. Gently let go of the third disc. If everything goes according to plan, you should be able to let go of the third disc and have a double-leaner! Further leaners can be placed against these ones following the same method.
-
Watch the standing pieces carefully. If they get too vertical, they will suck each other up. (Usually because the disc being played came in too vertical) If the leaner in the front gets too low, it will fall, and so will every other standing disc. (This might be a cool way to get a line of foundations quickly ??? )
+
If the leaner in the front gets too low, it will fall, and so will every other standing disc. This can a good way to get a line of foundations quickly.
These leaner lines are very unstable and can be good for offence.
These leaner lines are very unstable and can be good for offence.
http://www.dancingshadow.net/leaners.JPG
http://www.dancingshadow.net/leaners.JPG

Revision as of 09:44, 17 January 2006

Leaners in a Line

It is possible, though difficult, to stand discs on other standing discs. It is advisable to practice this technique without other magnets nearby. Note that in a game it is unlikely that an opponent will let you exploit this technique fully, and you might be limited to a small leaner chain.

Try to lay the first standing disc as low as possible. Bring the next disc along the mat carefully and slowly slide this disc towards the leaner until the leaner starts to wobble due to the disc you are moving. If the first leaner falls flat to the ground, then you probably placed it too far from the foundation disc. Slowly increase the angle of the third disc; the more vertical you make the third disc, the more vertical the second disc (the first leaner) will tend to become. And the more vertical the second and third discs are, the more their attraction will be to each other. Therefore, be sure to stop increasing the angle of the third disc as soon as you see the angle of the second disc increase. Slide the third disc back and at the same time lift it up some more: This is a tricky step: At the same time, you want to both barely tilt the third disc and barely move it away. Increasing the angle of the third disc increases the attraction it has to the second disc (preventing it from falling flat), while moving it away prevents the leaner discs from snapping together. It is important to note, however, that the movements in this step are very small. Any movement more than a millimeter is too large. Gently let go of the third disc. If everything goes according to plan, you should be able to let go of the third disc and have a double-leaner! Further leaners can be placed against these ones following the same method.

If the leaner in the front gets too low, it will fall, and so will every other standing disc. This can a good way to get a line of foundations quickly.

These leaner lines are very unstable and can be good for offence.

leaners.JPG

Personal tools