Speed bleeders

From 2nd Generation Rx7 Service Wiki

Speed Bleeders are produced by Speed Bleeder Products Inc. located in Newark, IL. The feature an internal check valve which makes bleeding brakes extremely easy. All you must do is crack the valve open, pump the pedal until no more air leaves the system, then tighten it until it seats again.

Contents 1 Sizing and Ordering 2 Using Speed Bleeders 2.1 Tools and Supplies 2.2 Speed Bleeder Installation 2.3 Speed Bleeder Bleeding

Sizing and Ordering

Sizes required are:

• S4 GTU, GXL, GTUs, Turbo = xxmm front, xxmm rear
• SE and S5 GTU = xxmm front, xxmm rear

Speed Bleeders can be ordered directly from the manufacturer's website at http://www.speedbleeder.com/ or can be found in any number of catalogs, including Victoria British.

Using Speed Bleeders

The first thing you'll need to do is install the Speed Bleeders into your calipers. The installation is very simple and straight-forward.

Tools and Supplies

You will need the following to complete the job:

• Flare wrench that fits Speed Bleeder
• 3-4 ft. of clear vinyl tubing that will fit snugly over the bleeder
• Catch container
• Fresh brake fluid

Speed Bleeder Installation

1. Jack the vehicle up, remove the wheels
2. Remove the bleeder from the caliper using a flare wrench (a normal wrench will strip the bleeder.) On the rear calipers, only remove the upper bleeder
3. Carefully thread the new bleeder into the socket. Be very careful not to cross thread the socket. The front calipers are aluminum and it doesn't take much to screw them up.
4. Tighten the bleeder in the socket

Speed Bleeder Bleeding

1. Jack the vehicle up, remove the wheels

---